Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

StagePVDescription
ADC Loop
:ADC:LOOPBACK_S
This control can be configured so that MBF ADC input is taken by looping back the DAC output instead of from the ADCs.  This mode of operation is designed for development only, and should not be used for normal system operation.  When loopback is enabled this control shows an alarm state.
ADC INP
:ADC:INP_OVF
The magnitude of ADC input is compared against the limit set in PV :ADC:OVF_LIMIT_S, and this indicator shows an alarm state if the magnitude is higher.  Typically this means that the MBF input is operating in the non-linear part of the ADC, leading to possible harmonic distortion.  To avoid this, reduce the signal gain applied to the ADC inputs.
ADC FIRCOMP
:ADC:FIR_OVF

It is possible for the input compensation filter :ADC:FILTER_S to result in overflow, in which case this indicator will show an alarm.  If this occurs the input data will be clipped.  To avoid this, reduce the overall gain of the filter by scaling the coefficients appropriately.

BB FIR
:FIR:OVF

At present it is possible for bunch by bunch FIRs with more than 8 coefficients to overflow internally if fed with a full scale input signal.  If this occurs this indicator will show an alarm, even if the FIR signal is not currently being sent to the DAC.  To avoid this, reduce the overall input signal level or reduce the gain of the FIR coefficients.

DAC BUN
:DAC:BUN_OVF
As the bunch by bunch FIR signal is prepared for output it is gated (selected or disabled by bank control) and scaled (by :FIR:GAIN_S).  At this point if overflow occurs this indicator shows an alarm.  Note that even if the FIR signal is not selected for output then no an alarm will may be shown here.
DAC MUX
:DAC:MUX_OVF
The DAC output multiplexer allows FIR and NCO outputs to be combined and scaled.  Two or more outputs can add to generate an overflow, in which case an alarm will be shown here.
DAC FIRPEMPH
:DAC:FIR_OVF
If the output pre-emphasis filter :DAC:FILTER_S results in overflow this indicator will show an alarm.  To avoid this rescale the filter coefficients.
DAC Enable
:DAC:ENABLE_S
This control is used to turn DAC output on or off.  When the DAC output is off this control is in an alarm state.

...