...
The controls at the bottom can be used to set or reset a selected range of bunches. For a detailed explanation of the bunch selection field see the Bunch Select Syntax of the Bunch Bank Control page, but a brief description of the "Set Bunches" section follows below.
| Name | PV | Description |
|---|---|---|
| Bunch FIR Select | :DET:n:BUNCHES_S | Waveform showing current bunch selection. Can be written directly, or through the control PVs below. |
| Set Bunches | :DET:n:BUNCH_SELECT_S | Used to select which bunches will be updated. See page linked above for details. |
| Status | :DET:n:SELECT_STATUS | Reports status of last attempted write to the bunch select field, see linked page for details. |
| Enable | :DET:n:SET_SELECT_S | Processing this PV enables the detector for the selected bunches. |
| Disable | :DET:n:RESET_SELECT_S | Processing this PV disables the detector for the selected bunches. |
For the Tune PLL detector bunch control the PV names are slightly different:
| Name | PV |
|---|---|
| Bunch FIR Select | :PLL:DET:BUNCHES_S |
| Set Bunches | :PLL:DET:BUNCH_SELECT_S |
| Status | :PLL:DET:SELECT_STATUS |
| Enable | :PLL:DET:SET_SELECT_S |
| Disable | :PLL:DET:RESET_SELECT_S |