Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The availability of the sample environment is indicated by the status icon, described in more detail below;

Status
colourGreen
titleAvailable
 = Environment is fully available to users and can be run as part of a routine experiment.

Status
colourYellow
titleAvailable
 = Environment is available to users but is not yet fully optimised. This could indicate that some equipment is not fully integrated into the beamline controls software or that users may require additional assistance etc.

Status
colourYellow
titleRequest
 = The environment is already in existance but has not been thoroughly tested by users.


Device List

Table of Contents
minLevel2

Hot Air Blower -
Status
colourGreen
titleAvailable

Used to heat capillary samples from room temperature up to 1100 K. Temperatures of up to 1200 K can be reached with smaller samples. The blower can be used in conjunction with a 7 position sample changer for spun capillaries.

 


Cryojet -
Status
colourGreen
titleAvailable

An Oxford Instruments Cryojet5 capable of cooling and heating capillary samples in the temperature range 85-500 K. The cryojet can be used in conjunction with a 15 position sample changer for spun capillaries. Both the cryojet and hot air blower can be mounted on the beamline at the same time to cover a wide temperature range. 


Eurotherm Temperature Controllers -
Status
colourGreen
titleAvailable

Two Eurotherm 3504 duel loop temperature controllers are available on the beamline. The output from these is 240 V AC (230 V AC) delivered through a Harting Han A series 4 connector.

 

eChem -
Status
colourYellow
titleAvailable

An 8-channel Ivium-n-Stat is available for in-situ electrochemical measurements and cycling. This can be used to perform in-situ PDF measurements on up to 8 batteries while they are cycling. Users can either bring their one battery cells or use the radial-geometry cells developed by Diamond staff.


Hydrothermal Cell -
Status
colourYellow
titleAvailable


A hydrothermal cell is available which is capable of operating up to 230°C. The cell design is optimised so that the only contribution to the background is that of the fused-quartz capillary holding the sample. The sample is sealed on a PTFE ferrule, minimising issues with chemcial compatibility.


Ion Exchange Cell -
Status
colourYellow
titleRequest

The ion-exchange cell is a liquid flow cell that is attached to a valve manifold. There is a pressure transducer to measure the back pressure throughout the scan to establish the stability of the column.



Gas cells -
Status
colourYellow
titleRequest

XPDF are commissioning a range of vacuum, static gas and flowing gas cells. If you are interested in learning more about what is possible, please contact xpdf@diamond.ac.uk.