(independent users) when starting a session without a staff to support you.
Before you start
Contact EHC
- Pick the phone, dial 8787;
- Speak to the EHC team and let them know that you are about to start your lone-working session now.
Pre-experiment setup
- Read the log from the green folder, making sure that there are no instrumentation problems reported by the previous user and that the microscope is ready for new experiments;
- Log in to the remote control computer with your Fed ID (e.g. clrc\abc00000) and password;
- Start all the needed remote desktops (e.g. View, TEM Center, Gatan, Cosmo, Merlin, EDS??);
- Check the vacuum values of all the pumps from TEM Center;
- Start data synchronisation with your session number (instruction available on the wall or here[link??])
After you finish
Contact EHC
- Pick the phone, dial 8787;
- Speak to the xxx to let them know that have finished your lone-working session.
| Info |
|---|
| Note |
If you are lone working please inform the experimental hall co-ordinators at the beginning and end of your session on 8787. |
| Warning |
|---|
The ERA form must be signed and displayed on the noticeboard outside the control room before beginning your experiment. |
Log into the control room computers using your fedID and password (these are the same details you use to log into the UAS- Here you have to include the domain in username: clrc\yourfedID).
Set up the data-dispenser if required.
Open the required remote desktops - passwords can be found in the blue folder.
- Open the required software if not already open.
- Set up auto-saving in Gatan Digital Micrograph (a folder will have been created for you on the local RAID drive at x:\SessionData\data\YYYY\emXXXXX)
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...