...
| Title | PV | Description | |||
|---|---|---|---|---|---|
| FIR select | :BUN:n:FIRWF:STA | Summary of FIR configuration | |||
| DAC out status | :BUN:n:OUTWF:STASTATUS | Summary of selected DAC output configuration | DAC gain | :BUN:n:GAINWF:STA | Summary of DAC output gain configuration |
For each monitored waveform the status report shows one of three things depending on whether individual bunches are have different configurations:
- If all bunches have the same configuration, a summary of that configuration is shown, eg "Sweep"
- If one bunch is different, but all the others are the same then the common configuration is shown followed by the unique configuration and bunch position, for example "FIR (Sw+FIR @100)" indicates a DAC output configuration with feedback on all bunches, and sequencer sweep on bunch 100 only.
- Otherwise the phrase "Mixed FIR", "Mixed outputs", "Mixed gains" is shown as appropriate.
...
Below the bank selection are three PVs that help with copying bank configurations:
| Name | PV | Description |
|---|---|---|
:BUN:COPY_FROM_S | Selects which of the four banks is to be copied. | |
| Copy Bank | :BUN:COPY_BANK_S | Copies the entire bank configuration state (FIR selection and all five source gains and enables waveforms) from the selected source to the selected destination bank. |
:BUN:COPY_TO_S | Selects which of the four banks is to be overwritten by the "Copy Bank" action. |
NCOs
This allows the two fixed frequency oscillator oscillators to be controlled. The following PVs are available, each prefixed with $(device):$(axis):$(nco) where $(nco) is either NCO1 or NCO2.
| Name | PV | Description |
|---|---|---|
| Frequency | :FREQ_S | The NCO frequency can be set to any value in units of cycles per machine revolution. |
| Gain | :NCO:GAIN_DB_S | This is shows the configured output gain in steps of 6dB dB with 0dB representing full scale DAC output. Clicking on this will bring up the NCO Gain Configuration where the gain can be adjusted. |
| Enable | :NCO:ENABLE_S | This must be set to "On" for NCO output to be generated. |
| Track PLL | :TUNE_PLL_S | If this is set to "Follow" then the generated frequency will be adjusted by the :PLL:NCO:OFFSET as managed on the Tune PLL screen. |