...
| Title | PVs | Description |
|---|---|---|
| Min/Max |
| Shows minimum and maximum value for each bunch over the sample period (configurable by setting :MMS:SCAN_S.SCAN and measured by :MMS:TURNS). |
| Difference | :MMS:DELTA | Shows the difference MAX-MIN. This is the most direct measurement of bunch motion. |
| Mean | :MMS:MEAN | Shows the average bunch position over the sample period. |
| Standard Deviation | :MMS:STD | Shows the standard deviation of the bunch motion over the sample period. This is a slightly more sophisticated measurement of bunch motion than Overlaid on this graph we have the following three curves. These all update at a slower interval, typically configured for every 60s, and are designed for long term archival. |
:MMS:STD_MEAN_WF | Mean value of :MMS:STD over the last archival interval. So long as :MMS:MEAN does not move this is reasonably close to the overall standard deviation over the archival interval. | |
:MMS:STD_MIN_WF, :MMS:STD_MAX_WF | Minimum and maximum value of :MMS:STD over the last archival interval. |
At the bottom of this screen we have the following indicators:
| Title | PV | Description | |
|---|---|---|---|
| Turns | :MMS:TURNS | This shows the number of turns used to sample the currently displayed graph. | |
| Mean mean | :MMS:MEAN_MEAN | This is the average of the position of all bunches over the sample period. | |
| Std mean | :MMS:STD_MEAN, :MMS:STD_MEAN_DB | This shows the average value of :MMS:STD, which can be used as a measurement of overall beam motion. The value is also available as a logarithm in dB. | |
| Source | : | MMS:OVERFLOWThis status indicator should always read "Ok". If any other value is indicated then a measurement error has occurred, probably due to a system misconfiguration. Any fault will remain shown until $(part):MMS_SOURCE_S | Shows the currently configured source for this display. |